This WCS probing generator is built for Fanuc based machines with Renishaw programs using the O95XX block of programs. Include any axes present for correct g-code output. The location values you enter should be based on the origin values from the WCS you are inspecting from according to your program WCS Origin.
ADVANCED PROBING AUTOMATION
ENTER THE PROBE TOOL NUMBER
ENTER THE WCS YOU ARE LOCATING FROM (54-59 / 54.1 P1=101,P2=102)
(54-59 / 54.1 P1=101, P2=102)
ENTER THE INITIAL SAFE CLEARANCE POINT IN Z
POSITION WHERE PROBE WILL MOVE TO START INSPECTION
POSITION WHERE PROBE WILL MOVE TO START INSPECTION
PROBE WILL MOVE TO THIS POSITION IN A PROTECTED MOVE AND BEGIN PROBING
LEAVE AT 0.00, THIS IS FOR ADDING TO G54 CALL ONLY
LEAVE AT 0.00, THIS IS FOR ADDING TO G54 CALL ONLY
LEAVE AT 0.00, THIS IS FOR ADDING TO G54 CALL ONLY
WIDTH OF FEATURE IN X TO INSPECT
WIDTH OF FEATURE IN Y TO INSPECT
INCREMENTAL DISTANCE FROM Z STARTING POSITION NEGATIVE IN Z
DIAMETER OF FEATURE
DISTANCE OF SURFACE FROM DESIRED WCS ORIGIN +OR-
G-CODE OUTPUT
IMPORTANT — VERIFY BEFORE RUNNING: Generated probing programs are programming aids. Review commands, offsets, machine compatibility, clearances and probe settings. Verify with controlled machine testing before production. The programmer is responsible for validation.